Eehe

' 6 SCREWS, U" WHITWOBTH) NUTS AND WASHERS

-WArJ

E. ASSEMBLY OF ROTOR THRESHER BEFORE FITTING OF CENTRE SHAFT BEARINGS

STAGE 4. ROTOR THRESHER ADJUSTING PLATES

MATERIAL : IV x IV X V MILD STEEL ANGLB NUMBER OFF i 2.

DRILL 5/16" DIA. HOLES ELONGATED IV

FIGURE 6. ASSEMBLY OF CONNECTING ROD AND ADJUSTING PLATES

FIGURE 6. ASSEMBLY OF CONNECTING ROD AND ADJUSTING PLATES

TWO 5/16" DIA. HOLES TO BE DRILLED IN TOP KRAME FOR LOCATION OF ADJUSTING PISTES.

CENTRE SHAFT PEDAL CRANK TO BE WELDED TO ADJUSTING PLATE IV FROM TOP OF ROD.

STAGE 5. DRIVE

DRIVE IS OBTAINED FROM A BICYCLE PEDAL CONNECTED THROUGH A HUB BEARING TO A T" 0 SPROCKET. A STANDARD BICYCLE CHAIN CONNECTS TEE SPROCKET TO SPROCKET ON CENTRE SHAFT.

THE DRIVE ASSEMBLY IS BOLTED TO THE LEFT HAND SIDE OF TOP FRAME APFBOX. 10" FrOM GUARD. ENSURE THAT THE TWO SPROCKETS ARE IN LINE BEFORE FITTING CORRECT LENGTH OF CHAIN.

FIGURE 7 SHOWS ASSEMBLY WITH DETAIL OF HUB BEARING FIXING PLATE.

FIGURE 7 SHOWS ASSEMBLY WITH DETAIL OF HUB BEARING FIXING PLATE.

STAGE 6. STAND

36"

STAGE 7.

delivery frame

24"

STAGE 8. INPUT TABLE

MILD STEEL ANGLE

OVERALL LENGTH 22"

12"

18"

il jcchzz

STAGE 9. DELIVERY TABLE

MATERIAL ; 20 a.w.g. MILD STEEL PLATE

3TAGE 10. TüSESHER PLATE

NO£5: ON ASSEMBLY THE THRESHER PLATE IS WELDED BETWEEN THE INPUT GAP AND THE DELIVERY TABLE.

THE GAP BETWEEN THE ROTOR AND THRESHER PLATE CAN BE ADJUSTED BY MOVING THE ROTOR THRESHER ADJUSTING PLATES.

the correct gap is approx v. fob guiheacoen (sorghum).

STAGE 11. FINAL ASSEMBLY

LOCATE INPUT TABUE 2N POSITION ON TOP FRAME (SEE COVER DRAWING)

LOCATE INPUT TABUE 2N POSITION ON TOP FRAME (SEE COVER DRAWING)

LOCATE DELIVERY TABLE IN POSITION IN DELIVERY FRAME (SEE COVER DRAWING*

WELD THRESHER PLATE IN POSITION ¿ND ADJUST GAP (FIG. 10),

CLEAN WELDED AREAS LUBRICATE AND PAINT

GUARD

GUARD

FIGURE 10.

WELD

THRESHER PLATE

WELD

WELD

THRESHER PLATE

FIGURE 10.

WELD

0 0

Post a comment