Directions

The bevel across the sides of stock at ends of standards and in standards for steps is marked off with the T bevel, set at 6" on the blade and 3" on the tongue of the steel square.

The bevel at ends of standards and steps across the edge of stock is marked off with the T bevel set at 6" on the blade and 15/16" on the tongue of the steel square.

The steps are gained into the standards y8".

Four 2" No. 10 wood screws are placed thru the top at each end, two into the brace and two into the standard.

The braces are held to the standards with three IV2 No. 8 wood ' screws.

The rods may be threaded and held with a nut at each end.

A 14" x 1 Vfe" carriage bolt is used to fasten the chain to the bottom of the middle step. The chain may pass around the brace and be fastened with staples or by placing a bolt thru a link and thru the brace.

0 0

Post a comment