Hardware

32 wagon box rivets for floor boards.

12 wagon box rivets }4"x2" for rear end gate and side cleats. 16 wagon box rivets WxlW for rub irons, braces and foot boards. 2 wagon box rivets for rear end braces.

8 wagon box rivets 1A"x2Y^// braces for front end gate and front side cleats.

6 braces as shown in detail drawing. 2 rub irons shown in detail drawing. 4 rectangular washers as shown in detail drawing. 8 wagon box strap irons as shown in detail drawing. 2 front end gate braces as shown in detail drawing. 2 wagon box rods.

4 doz. flat head wood screws for fastening axle support to box and axle guides to axle support. 31 ft. of beveled or half oval wagon box strap iron with screws.

Wagon boxes usually wear out at the part over the rear axle. This may be prevented by fastening a 10" board beneath the box where it rests on the axle.

To hold the box in place cleats are fastened beneath the 10" board so that one will be in front of and the other back of the axle. The distance between cleats is 394" or 4" as determined by the width of the axle.

Fijr. 19. Bottom of Wagon Box.

0 0

Post a comment